Nano-based Chip Detects Explosives

Technical University of Denmark (DTU) is ready with a prototype for a chemical “sniffer system” for the detection of criminal substances like narcotics and explosivesDogs have an eminent sense of smell. Their snouts use a specific sniffing technique which almost grabs hold of scents. Elephants’ snouts are even better than those of dogs, but obviously these are attached to elephants which are difficult to carry around. Consequently, today dogs are employed to track narcotics, money and explosives. Sometimes dogs are able to sense explosives in very small doses, however, they are not always 100 percent reliable as they are also sensitive to changes in their surroundings. A technological solution is therefore to be preferred in the tracking of stocks of narcotics or explosive materials.

Researchers at DTU have developed the prototype of a chip able to sniff molecular structures from a number of known substances. A special camera visualises the results from the chip (with 24 megapixels per 15 second) and newly developed software interprets these images according to changes in colour (i.e. the difference between two pictures), caused by the impact of the scents in the air.

We have conducted experiments by sucking air from smaller containers like e.g. handbags or pieces of luggage and from large industrial sized containers typically used for smuggling. In both cases, we arrived at promising results”, says Mogens Havsteen Jakobsen, Senior Researcher at DTU Nanotech.

By using the so-called colorimetric sensing technique, the artificial nose is able to detect different substances like explosives, narcotics, the ripeness of cheese, rotten meat and fish, the quality of wine and coffee or bad indoor climate of a room.

The project has specifically targeted explosives which are a growing safety risk in our society. The Chemical Division of the Danish Emergency Management Agency has been an important collaborator because they are authorised to produce and handle explosives. “We have test laboratories which have been made available during the course of the project”, says Jesper Mogensen, civil engineer and analysis chemist at the Chemical Division and therefore used to handling explosives.

There will be some evident advantages in using a technology such as CRIM-TRACK, compared to the instruments available today,” Jesper Mogensen says. “Firstly, the preparation time is short in that what you largely need to do is switch on the tracker and use it. This is valuable time saved. Secondly and perhaps the most important advantage is the fact that the EOD (the Explosive Ordnance Disposal) does not need to collect a sample. Today when we are called to a ransacking if e.g. a kilo of white powder has been found and we have to analyse its chemistry by way of GC-MS (i.e. gas chromatography-mass spectrometry), a sample of the substance must be collected on a fibre. In other words, it is necessary to collect physically a sample with all the risks this entails. With DTU’s sniffer system, it is possible to collect samples in the air. It sniffs for the drug much like a dog and indicates whether there are any explosives or not. This will increase the safety of our EOD”.

Source: http://www.nanotech.dtu.dk/

How To Store Electricity In Paper

Researchers at Linköping University’s Laboratory of Organic Electronics, Sweden, have developed power paper – a new material with an outstanding ability to store energy. The material consists of nanocellulose and a conductive polymer.

One sheet, 15 centimetres in diameter and a few tenths of a millimetre thick can store as much as 1 F, which is similar to the supercapacitors currently on the market. The material can be recharged hundreds of times and each charge only takes a few seconds.

It’s a dream product in a world where the increased use of renewable energy requires new methods for energy storage – from summer to winter, from a windy day to a calm one, from a sunny day to one with heavy cloud cover.

Power-paper

Thin films that function as capacitors have existed for some time. What we have done is to produce the material in three dimensions. We can produce thick sheets,” says Xavier Crispin, professor of organic electronics and co-author to the article just published in Advanced Science.

The material, power paper, looks and feels like a slightly plasticky paper and the researchers have amused themselves by using one piece to make an origami swan – which gives an indication of its strength.

The structural foundation of the material is nanocellulose, which is cellulose fibres which, using high-pressure water, are broken down into fibres as thin as 20 nm in diameter. With the cellulose fibres in a solution of water, an electrically charged polymer (PEDOT:PSS), also in a water solution, is added. The polymer then forms a thin coating around the fibres.

The covered fibres are in tangles, where the liquid in the spaces between them functions as an electrolyte,” explains Jesper Edberg, doctoral student, who conducted the experiments together with Abdellah Malti, who recently completed his doctorate. Other co-authors are researchers from KTH Royal Institute of Technology, Innventia, Technical University of Denmark and the University of Kentucky.

The results have been published in Advanced Science.

Source: http://www.liu.se/